![]() Insist especially on the parts where the design has very small details.Ġ3- Take measurements of the wall and adjust the space for the sticker.Ġ4- Bend the white silicon paper about 5 centimetres from the top.Ġ5- You stick the upper part of the sticker onto the wall in order to secure the sticker on the wall before removing the whiteĠ6- You then remove the white paper at the back of the sticker as you press the sticker down. If you ordered a photo mural, please be sure that there aren ́t any missing piecesĠ2- Use the spatula very hard across the whole surface of the protective paper to ensure that the sticker sticks properly. Or more pieces (in the same cardboard tube). ![]() Depending on the size of your sticker, your delivery may come in one Have a table or a floor ready, andĬheck that it is the correct sticker that you have ordered. Vinyl is a flexible material and therefore any wrinkle that affects the paper has no effect on the vinyl once the application is done correctly.Ġ1- You remove the seal from the cardboard tube take out the sticker and the template. When you receive the package we recommend to extend the vinyls and put pressure on the wrinkles, press again with the spatula or a similar object before the application. **The wrapping of the vinyls into the tubes might cause some wrinkles in the conveyor paper that is used to facilitate the application. The slightest irregularity on the surface will affect the writing and erasing on the board. * If you have purchased a vinyl blackboard sticker you have to place in an absolutely smooth surface. If yours is otherwise please contact to find a solution. The stickers sold by Tenstickers are for any smooth non-porous surface. We recommend cleaning the surface with water or cleaning alcohol from the pharmacy. This product leaves particles that are not compatible with the adhesive. Never clean the surface with glass cleaner. If the application surface of the sticker has been painted recently, we recommend a period of about 4 or 6 weeks before applying the sticker. We do not recommend the application of our stickers on freshly painted surfaces. ![]() We recommend that if you ́re going to stick your sticker on a painted wall, it should be plastic paint as this is the most recommended. The surface must be dry, free from dirt and impurities such as powder, liquids and stains. You will need to make sure that the surface where you will be sticking the sticker onto is in good condition otherwise the durability of the sticker is not guaranteed as the grip won't be correct. If you won ́t be applying the sticker until a few weeks later, then it will be better to take the sticker out of the tube/bubble envelope and keep it stretched out. Also, we have attached a copy of the design to be used as a proportional template sheet sticker so you can make adhesion and application tests before applying your acquired vinyl sticker. In the case that you also purchased a spatula, this will also be inside the tube/bubble envelope. You will receive a cardboard tube packaging/bubble envelope that protects the sticker and its accessories from any damage. 1- A spatula or similar (credit card, ID) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |