See also below, how the install mode can be set in a silent installation. Downside is that the path is longer and it often leads to incompatibilities with compilers and build scripts, if the username contains spaces or non-ASCII characters.In this case the ruby installation is completely private and not visible to other users.This is the same installation procedure as the first one, but the base directory in the following installer steps can be changed to be inside the private user folder.Single user install into C:/Users//Rub圓2-圆4 or similar.It's also possible to manually grant write access to a particular group of users, so that they can install gems and pacman packages in the common location (in addition to administrators).However it is not possible for an ordinary user to install new pacman packages. Gems can either be installed centrally by an administrator or are automatically redirected to a private per-user folder, if the user has no write access to the central directory. Ordinary users can use a common ruby installation, but don't have write permissions to the ruby directory.This allows a single ruby installation to be used by multiple users.All-users install into C:/Rub圓2-圆4 or similar.It is the best option for the common use case of only one user on the computer. The installing user (and administrators) has write access to the ruby directory.This is the default and the recommended way to install Ruby on Windows.Single user install into C:/Rub圓2-圆4 or similar.This allows the selection of the following two installation modes: How to verify PGP signature of download files?Ī: Recent RubyInstaller's show an selection dialog at the very first stage:.How does RubyInstaller-2.4+ handle SSL certificate authorities?.Can RubyInstaller2 be used without installation (e.g.What is recommended way to update a Ruby installation?.Can I automate the Ruby and MSYS2 installation?.How do I perform a silent install with the RubyInstaller?.Are there recommendations for working with rails?.Can I share one Devkit for multiple Ruby versions?.What do the RubyInstaller-2.4+ install components do?.This saves you a lot of trouble if you later want to run your Ruby programs on, say, Linux, or in a Cygwin environment. Just one note for the practical side: Once you have installed the text editor of your choice, set it up so that it generates files with just LF line endings (the default on Windows is usually CR LF). Basically, you need two things for a start: A good text editor, and a console (which could be the Windows command prompt console), from which you will start several instances (some of those consoles running irb, some just the command prompt of your shell). I understand that, if you are new to programming in general, this might sound a bit complicated. Since I don’t like neither the “old” Windows “DOS-shell” nor the Power Shell, I’m using on Windows the Cygwin environment, and within it I use the Z-Shell (zsh) as a shell, and mintty (which is also a Cygwin program) as a console (which I also prefer over the Windows console), but here again, this is a personal choice. I find for many tasks using a shell easier than doing it from Ruby. Technically you could do all of this from within irb, but to what extend you consider it convenient, you have to find out by yourself. One (or more) running irb, where I can quickly try out some Ruby expression (this is why I don’t have any need to just syntax-check them - I want to run them!) and one or more windows running some shell, from where I’m launchin programs and so on. I usually work with several console windows open. Well, you didn’t say that you are on the Windows operating system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |